Do you have any questions or suggestions? Contact us - we will be happy to help you. Please note that the automatic component design is always carried out on the basis of the load cases defined by you during the calculation and only the stress that occur are taken into account. The deformation is not examined. We will be happy to support you in model building to avoid incorrect assumptions. PROTIQ GmbH and AMendate GmbH do not guarantee the correctness of the calculation and refer to the applicable liability provisions. Following the automatic component design (online topology optimization), we recommend a final FEM calculation of the generated geometry for consideration of the stiffness and validation of the results. We would be pleased to carry out the FEM calculation as a service for you. With the help of our engineering team you are on the safe side. We look forward to your message!